Hydraulic unit for combustion systems with axial piston pumps, proportional technology in combination with On/Off direction control valves. Oil/air cooling unit with temperature control, all outlets monitored with pressure switches. Oil tank and oil sump per WHG (Water Management Act) 19.

Hydraulic unit with redundant piston pumps, high-pressure filters and plate heat exchanger. Separate oil tank and structure of the hydraulic unit with damping elements.

Lubricating oil unit for high pressure lubrication and low pressure lubrication with gear pumps and piston pumps. The requirements of hydrostatic bearing lubrication are met here by oil heating, oil cooling, micro filters and special dosing pumps. The lubricating oil unit is delivered ready for connection thanks to the wiring of all switching devices.

Hydraulic unit with a specially service-friendly design. Two separate oil circuits in a separate oil tank. Easily accessible axial piston pumps with output regulators serve 11 power-consuming devices via 4/3-way valves in proportional technology with emergency activation by a lever. Oil temperature is controlled via oil heating and oil/air coolers.

Oil-submerged hydraulics is a speciality of K+S Hydraulik. Here a motor submersible in oil drives 2 internal gear pumps for 2 separate pressure systems. With this compact device with installed output of 5.5 KW at pressure of up to 280 bar, noise pollution can be reduced to 64 dBA.

Test bench hydraulics in a soundproof housing. K+S Hydraulik manufactures these test benches to customers’ requirements. Here fitted with sliding vane pump and screw spindle pump.

Oven hydraulics including electrics, designed ready to connect and user-friendly. Axial piston pumps supply the systems for feed hydraulics and actuator hydraulics. Noise reduction by damper rings and hose cables. Feed filter and return filter in combination with an oil/air cooler ensure reliable operation.

This hydraulic unit is used for test bench hydraulics. An internal gear pump (manuf. Bucher) and a radial piston pump meet the various pressure requirements. This hydraulic unit is designed to optimise noise levels with damper rings and all the hydraulic accessories incl. oil sump, designed and approved per WHG 19.

Hydraulic unit for an industrial oven. A high-pressure gear pump feeds a valve block for 6 power-consuming devices. The stop valves, throttle valves and pressure valves are installed as CETOP valves under the 4/3 –way valves. Pressure switches and pressure accumulators allow acceleration and positioning of the power-consuming devices.

Lubricating oil unit for a complete lubricating oil system with high-pressure lubrication and low-pressure lubrication. Special dosing pumps take the load off the bearings by hydraulics in the high pressure circuit and gear pumps supply lubricating oil and cooling oil. The components are built on to a separate oil tank with an oil sump per WHG 19. To allow controlled and reliable operation the lubricating oil unit is equipped with, among other things, pressure switches and double switch filters.

High-pressure hydraulics for forming technology. The electric motor drives a double pump consisting of a gear pump of up to 120 bar and a piston pump of up to 600 bar. The power-consuming devices may be connected to a distributor block and a pressure accumulator serves to keep the pressure constant.

Complete oil preparation for stamping technology. The oil heavily contaminated with residues is precleaned with gear pumps protected from wear in a centrifuge and then subsequently treated with micro filters. The complete oil cleaning system with all its filter stations and automatic flow control was handed over ready to run by K + S Hydraulik to the customer.